B4000 V6-4.0L SOHC (2005)
5. Remove the restraint system diagnostic tool from the clockspring electrical connector at the top of the steering column.
6. Position the driver air bag module.
1. Connect the driver air bag module electrical connector.
2. Position the driver air bag module to the steering wheel.
7. Install the two driver air bag module bolts (one shown).
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
8. Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
9. Turn the ignition from OFF to ON
10. Install the restraint system control module fuse 8 (10 A)to the SJB.
WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
11. Connect the negative battery cable. See BATTERY DISCONNECT.
12. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag supplemental
restraint system (SRS) fault is present, the air bag indicator will either:
-
fail to light.
