B4000 V6-4.0L SOHC (2005)
Steering Angle Sensor: Service and Repair
STEERING SENSOR RING REMOVAL / INSTALLATION
Caution:
^
The steering column must be in the locked position, or the lower end of the column wired In such a way that the steering column does not rotate,
resulting in damage to the air bag sliding contact.
Note:
^
Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; install a new bolt.
1. Remove the upper intermediate steering shaft to column shaft bolt.
1
Remove and discard the steering column shaft pinch bolt.
2
Slide the intermediate shaft yoke from the steering column.
2. Remove the shock absorber electronic steering sensor.
1
Disconnect the electrical connector.
2
Remove the screws.
3
Remove the shock absorber electronic steering sensor.
3. Remove the sensor ring.
1
Remove the steering column lower bearing spring.
2
Remove the sensor ring.
4. Install in reverse order of removal.