B4000 V6-4.0L SOHC (2005)
6. Using the special tool, separate the outboard front wheel halfshaft joint from the wheel hub. Remove the special tool.
7. Disconnect the front anti-lock brake sensor (ABS) wire from the vehicle frame.
1. Disconnect the ABS electrical connector.
2. Unclip the front ABS wire from the vehicle frame.
8. Using a suitable jack, support the front suspension lower arm.
Caution:
^
Secure the front axle shaft to prevent it from overextending. Failure to do so can cause damage to the front axle shaft.
9. Support the front axle shaft with wire.
10. Remove the tie-rod end castellated nut.
1. Remove and discard the cotter pin.
2. Remove and discard the castellated nut.
