B4000 V6-4.0L SOHC (2005)
Torsion Bar: Service and Repair
Torsion Bar Removal
Torsion Bar Removal
1. Raise the vehicle on a hoist.
2. Remove the torsion bar cover plate.
1
Remove the bolts.
2
Remove the cover plate.
3. Make preliminary adjustment references.
1
Measure and record the length where indicated.
4. Relieve the torsion bar tension.
1
Position SST 204-185 and the adapters.
2
Tighten the torsion bar tool until the torsion bar adjuster lifts off of the adjustment bolt.
Caution:
^
The torsion bar adjustment bolt is coated with dry adhesive, and must be replaced if it is backed off or removed. Failure to do so can cause
the adjustment bolt to loosen up during operation and a loss of vehicle alignment.
