B4000 V6-4.0L SOHC (2005)
5. Compare the results.
^
If one side sounds significantly louder than the other, go to Step 9.
^
If both sides sound equally loud, go to Step 9.
^
If both sides sound similar (not loud or noisy), wheel bearings are OK.
Note:
0 Make sure the wheel rotates freely.
Note:
^
Rotate the hub-locks to the unlocked position.
6. Carry out the following steps for the wheel bearing endplay setup:
^
Install the special tool to the knuckle.
^
Place the probe on the brake disc where the splash shield has a "V" opening.
^
Make sure the probe can move in a lateral direction.
^
Tighten the neck of the probe.
7. Carry out the following steps for the wheel bearing endplay:
^
Push the wheel inward at the 6 o'clock position.
^
Set the dial indicator to zero.
^
Pull the wheel outward at the 6 o'clock position.
^
Record the measurement.
^
Repeat this step 3 to 5 times.
^
If the wheel bearing endplay is greater than 0.13 mm (0.005 inch), install a new wheel bearing.
^
It the wheel bearing endplay is less than 0.13 mm (0.005 inch), the wheel bearing is within specification. Go to the next step.
