B4000 V6-4.0L SOHC (2005)
1
Connect shift solenoid electrical connectors.
2
Connect the TCC solenoid electrical connector.
3
Connect the EPC solenoid electrical connector.
Caution:
^
Excessive pressure may break the retaining pins.
4. Install the main control valve body wire loom.
1
Align the retaining pins to the holes in the solenoid clamps and gently press in the main control valve body wire loom guide and protector.
5. Install the oil strainer.
1
Install the oil strainer.
2
Install the bolt.
6. Position a new gasket on the oil pan.
7. Align and install the oil pan.
1
Loosely install the 18 oil pan bolts.
Note:
^
Use a crisscross sequence to tighten the transmission oil pan bolts.
8. Tighten the bolts.
9. Lower the vehicle.
