B4000 V6-4.0L SOHC (2005)
2. Install the reverse band servo piston and rod into the servo bore along with a reverse servo return spring.
3. Install SST.
1
Install a new reverse servo separator plate cover gasket.
2
Tighten the three screws.
4. Tighten the servo gauge adjusting screw.
5. Install dial indicator with brackets on the transmission case.
1
Position the indicator on the piston pad.
2
Set the dial indicator to zero.
Note:
^
If the piston travel in this step is 3 - 5.6 mm (0.120 - 0.220 inch), it is within specification. If the piston travel is greater than 5.6 mm (0.220
inch), use the next longer piston and rod. If the piston travel is less than 3 mm (0.120 inch), use the next shorter piston and rod.
