B4000 V6-4.0L SOHC (2005)
8. Remove the extension housing. Discard the extension housing gasket.
Installation
1. Clean the extension housing and install new extension housing gasket. Make sure that the parking pawl, spring and shaft are correctly installed.
Caution:
^
Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
2. Install the extension housing.
1
Position the extension housing.
2
Install the extension housing screws.
3
Install the extension housing studs.
3. Install the transmission mount.
1
Position the transmission mount on the extension housing.