B4000 2WD V6-4.0L OHV (1994)
^
Tighten the nut, but do not allow it to contact the plastic sleeve on the "slide bar" (refer to Figure 11).
NOTE:
The "slide bar" must be able to move easily forward and rearward prior to installation of the seat assembly in the vehicle.
4.
Position the seat assembly in the vehicle, install the screws, seat tracks to the floor as follows:
^
Hand start the front and rear seat track-to-floor retaining screws.
^
For proper alignment, first torque the front attachments to 12-23 N.m (9-17 lb.-ft). Torque the rear attachments to 19-26 N.m (14-19 lb.-ft).
5.
Align the rear attaching hole in the "slide bar" assembly with the attaching hole in the floor. Be sure the rubber spacer is in place between the slide
bar" and the floor attachment (refer to Figure 12).
6.
Position the "slide bar" boot to the "slide bar" assembly. Then install the Torx bolt through the boot, "slide bar", rubber spacer, and into the weld
nut provided in the floor (refer to Figure 12). Hand start the retaining bolt into the weld nut.
