mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Parking Brake - Goes to Floor With Little Effort|Page 5084 > < Parking Brake - Goes to Floor With Little Effort|Page 5078
Page 1
background image

Parking Brake System: All Technical Service Bulletins
Parking Brake - Goes to Floor With Little Effort

Bulletin No.: 005/94
Issued: 5/6/94
Revised

Category

P

Applicable Model/s 
1993-94 Navajo 
1994 B-Series

Subject:
PARKING BRAKE GOES TO FLOOR WITH LITTLE EFFORT WHEN APPLIED

APPLIED MODELS 
All 1993-94 Navajo 
All 1994 B-Series

DESCRIPTION 
While being applied, the parking brake may go to the floor with little effort. This is caused when, after rapid pedal application, the parking brake pawl
may not engage completely with the parking brake ratchet. This results in the parking brake pedal depressing with little resistance.

To correct this problem, install a lock-in wedge between the pawl and the ratchet. This wedge maintains alignment of the pawl with the teeth of the
ratchet.

NOTE:

When the wedge is installed, the parking brake will not self adjust. Adjustment of the parking brake must be made with the wedge removed.

Wedge installation procedures are listed in this bulletin.

PARTS INFORMATION

Part Number

Description

ZZM0 28 117

Wedge

WARRANTY INFORMATION 
(Applies To Vehicles Covered Under Normal Warranty)
Warranty Code:

A

Customer Comment Code:

67

Damage Code:

99

Part Number Main Cause:

ZZMO 28 117

Operation Number/Labor Hours:

YY0L36RX / 0.3Hrs. (Wedge Installation With Parking Brake Adjustment)

REPAIR PROCEDURE

1.

Park the vehicle on a flat area with ignition off.
^

A/T in "PARK"

^

M/T in "1st" or "Reverse".

Parking Brake - Goes to Floor With Little Effort|Page 5084 > < Parking Brake - Goes to Floor With Little Effort|Page 5078