B4000 2WD V6-4.0L OHV (1994)
Crankshaft Position Sensor: Testing and Inspection
1. Disconnect the Ignition Control Module connector.
2. Measure the resistance between the following terminals in the harness side of the Ignition Control Module plug connector.
Measure between harness terminal 5 (DL) and 6 (GY).
Specification: 2580-2700 Ohms
3. If not within specifications;
-
Check harness between Ignition Control Module and Crankshaft Position Sensor.
-
If wiring is OK replace Crankshaft Position Sensor.
