B4000 2WD V6-4.0L OHV (1994)
Ignition Control Module: Service and Repair
View: Ignition Control Module
REMOVAL
1. Disconnect the electrical connector from the Ignition Control Module.
2. Remove the Ignition Control Module retaining bolt and remove the module by sliding the assembly up until it is released from the teardrop shaped
hole in the sheet metal.
INSTALLATION
1. Place the module on the sheet metal so the retaining rivet passes through the hole, then slide the module down into position. Install the retaining
bolt bolt and torque to: 3-4 Nm (27-35 in.lb.).
2. Connect the electrical connector to the module.
