B4000 2WD V6-4.0L OHV (1994)
Clutch Slave Cylinder: Service and Repair
Clutch Release Cylinder
CLUTCH RELEASE CYLINDER
REMOVAL/INSTALLATION
Caution: Be careful not to spill clutch fluid on a painted surface. If spilled, wipe it off immediately.
1. Disconnect the clutch pipe from the transmission using Clutch Disconnect Tool T88T-70522-A, or equivalent.
2. Remove the transmission.
3. Remove in the order shown in the figure,
4. Install in the reverse order of removal,
5. After installation, bleed the clutch system. See: Clutch Master Cylinder/Service and Repair
Clutch pipe
Caution: After removing the clutch pipe, plug it to avoid fluid leakage.
1. Disconnect the clutch pipe by using Clutch Disconnect Tool T88T-70522-A, or equivalent.
2. Slide the white plastic sleeve toward the clutch release cylinder while applying a slight tug on the pipe.