B4000 2WD V6-4.0L OHV (1994)
Transmission Position Switch/Sensor: Service and Repair
Component (M/T)
REMOVAL
1. Disconnect the negative battery cable.
2. Raise the vehicle on a hoist and position safety stands under the vehicle.
3. Disconnect the Park/neutral Position Switch connector.
4. Remove the switch.
INSTALLATION
1. Apply a suitable sealent to the threaded portion of the Park/neutral Position Switch.
2. Install the Park/neutral Position Switch.
Tightening torque: 25-35 Nm (18-25 ft.lb.)
3. Connect the Park/neutral Position Switch connector.
4. Remove the safety stands and lower the vehicle.
5. Connect the negative battery cable.
