B4000 2WD V6-4.0L SOHC (2003)
17.
Detach all connectors attached to seat cushion frame.
18.
Remove seat cushion/frame assembly from seat assembly and place upside down on a clean blanket or fender cover.
19.
Remove sides of seat cushion trim attached at tabs on seat cushion frame.
20.
Pull seat cushion trim off of seat cushion.
21.
Remove seat cushion trim from metal frame by cutting off all "hog" rings.
CAUTION:
Use care not to damage the seat cushion trim; it will be reinstalled onto the new seat cushion.
22.
Obtain new seat cushion.
23.
Reinstall old seat cushion trim onto the new seat cushion.
24.
Using new "hog" rings, reinstall seat cushion onto seat cushion frame.
CAUTION:
To prevent damage to the seat cushion trim, make sure to position sharp tips of hog rings downward.
25.
Inspect the seat cushion trim for any wrinkles and correct if necessary.
26.
To reinstall seat cushion onto seat assembly, reverse removal procedures.
27.
To reinstall seat assembly into vehicle, reverse removal procedures. Seat frame bolt torque: 37-53 N.m (27-39 Ft-lb).
28.
Repeat Steps 3 - 27 to repair passenger's side seat.
29.
Reconnect negative battery cable.