B4000 2WD V6-4.0L SOHC (2003)
1.
Disconnect the Brake Pressure Switch electrical connector N-138
2.
Remove the Brake Pressure Switch
3.
Fill the new Brake Pressure Switch with High Performance DOT 3 Brake fluid
4.
Install the Brake Pressure Switch into the Brake Master Cylinder
5.
Torque the Brake Pressure Switch to 17 Nm (13 lb-ft)
6.
Connect the Brake Pressure Switch electrical connector N-138
7.
Bleed the brake system see Workshop Manual Section 04 BRAKE SYSTEM BLEEDING 04-11-1
Disclaimer
