B4000 2WD V6-4.0L SOHC (2003)
7. Before installing the adapter jumper harness, fill the vehicle harness end of the jumper (male pin connector end) with electrical grease.
8. Install the adapter jumper harness (A) by connecting it to both the CCDS (B) and the vehicle harness (C).
Using the provided tie strap, secure the adapter jumper harness to a nearby component such as the cruise control cable or another wire harness.
^
If the vehicle has a cruise control servo, proceed to "D. CRUISE CONTROL SERVO INSPECTION".
^
If the vehicle does not have a cruise control servo, proceed to "E. CAMPAIGN LABEL INSTALLATION".
D. Cruise Control Servo Inspection
D. CRUISE CONTROL SERVO INSPECTION
1. Disconnect the cruise control servo and inspect the vehicle harness connector (A) for heat damage.
^ If no heat damage is found at the cruise control servo connector (even if there is presence of brake fluid in the connector), proceed to step 2.
^ If heat damage is found, call the Mazda Technical Hotline for further instructions.
