B4000 2WD V6-4.0L SOHC (2003)
Hydraulic Hose: Service and Repair
CLUTCH PIPE REMOVAL / INSTALLATION
1. Remove the clutch master cylinder and the hydraulic line assembly.
2. Disconnect the hydraulic line from the clutch master cylinder.
(1) Using a 3/32inch punch and hammer, drive out the roll pin and discard it.
(2) Disconnect the hydraulic line.
3. Connect and secure the hydraulic tube to the clutch master cylinder.
(1) Install the tube to the to the clutch master cylinder.
(2) Install a new roll pin.
Note:
^
Make sure the O-ring is in the outlet port or on the tube connector.
4. Install the clutch master cylinder and the hydraulic line assembly.
5. Bleed the clutch hydraulic system.
