B4000 4WD V6-4.0L OHV (1995)
5. Loosen CID sensor hold down bolt and remove it.
6. Lubricate oil pump drive pinion and O-ring on assembled oil pump drive gear and CID sensor with engine oil.
Note: Do not get oil above mounting flange.
7. Align the CID sensor rotor as shown with the trailing edge of the vane lined up with the short mark at the left hand side of the plastic window.
8. Position the sensor above its hole at right angles to the block rear face.
9. Install the assembled CID sensor and oil pump drive gear into the engine. As the assembly is pushed into place, the camshaft gear will rotate the
sensor vane clockwise toward the center of the window.
10. Rotate the CID sensor counterclockwise. Install clamp and screw finger tight. Rotate the sensor back to its position at right angles to the back of
the block.
11. Install the Breakout Box (49 UN01 130) to the PCM.
12. Connect the voltmeter positive lead to terminal number 85 and the negative lead to terminal number 103.
13. Rotate engine two revolutions to take up slack in timing chain and return No. 1 cylinder to its compression stroke.
Note: No. 1 cylinder must be at 26 degrees After Top Dead Center (ATDC) to set CID sensor
