B4000 4WD V6-4.0L OHV (1995)
1. Connect the universal fused jumper harness to the CCDS and the vehicle harness.
2. Position the harness (A) alongside an existing harness, located below or next to the master cylinder so that the fuse holders (C) are higher than the rest
of the jumper harness. This will cause any water that enters the engine compartment and gets on the jumper harness to run downhill away from the fuse
holder.
3. Secure the jumper to the existing harness with tie straps (B), making sure the fuse holder is positioned vertically with the cap facing upward. Wrap the
tie straps underneath, then over the top of the existing harness and verify proper fuse holder orientation.
4. Proceed to "E. CAMPAIGN LABEL INSTALLATION"
Procedure 2 - For Vehicles With Leaking Switches
PROCEDURE 2 - For vehicles with leaking switches
CRUISE CONTROL DEACTIVATION SWITCH (CCDS) REPLACEMENT
NOTE:
The brake pedal must not be depressed during the removal and replacement of the CCDS.