B4000 4WD V6-4.0L OHV (1995)
7.
Remove the forward glass run lower attachment bolt. Refer to figure 2.
NOTE:
Glass run removal does not require door glass removal.
8.
Remove the glass run from the door while the window is in the open position.
9.
Install the new glass run assembly. Refer to figure 3.
a.
Carefully install the rigid section of the glass run into the door and align the glass run bracket hole with the hole in the inner door panel.
b.
Carefully install the rigid section of the glass run into the door and align the glass run bracket hole with the hole in the inner door panel.
c.
Position the new glass run so that the top comer of the rigid section is fully seated in the corner of the "A" pillar and aligned.
d.
Seat the glass run from point "X" to point "Y."
e.
Seat the upper rear corner "Z" leaving a gap between the "Z" and the "Y" point.
f.
Seat the end most portion of the glass run into the bottom portion of the door "W" leaving a gap between points "Z" and "W."
NOTE:
Confirm that the upper rear corner is fully seated prior to completing the installation.