B4000 Regular Cab 4WD V6-4.0L OHV (1997)
8. Remove the cylinder head cover and gasket.
INSTALLATION
1. If installing the left cylinder head cover, perform the following:
a. Install a new cylinder head cover gasket.
^
Apply sealant to the seam between the lower intake manifold and cylinder head and an 8mm (0.125 in) ball to each bolt hole on the exhaust
manifold side of the cylinder head cover as shown.
^
Tighten the cylinder head cover bolts to 6-8 Nm (4.5-5.9 ft. lbs.)
b. Install the cylinder head cover, reinforcement plates and left cylinder head cover bolts.
c. Position the fuel hoses correctly and install the fuel hose clip bolt.
d. Install the left wiring harness and push down on the clip.
