mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Heater Core - Thump Noise/Temperature Gauge Erratic|Page 5032 > < Heater Control Valve|Testing and Inspection|Page 5023
Page 1
background image

Heater Core: Customer Interest
Heater Core - Thump Noise/Temperature Gauge Erratic

Bulletin No.: 001/97
Issued: 12/28/97
Revised

Category

E

Applicable Model/s
1994 Navajo
1994 - 97 B4000

Subject:
TEMPERATURE GAUGE FLUCTUATION THUMP NOISE FROM COOLING SYSTEM

APPLICABLE MODELS
1994 Navajo
1994 - 97 B4000

DESCRIPTION

Vehicles may experience a thump noise from the heater core that may be accompanied by excessive temperature gauge fluctuation. This noise is caused
by the water pump delivering an uneven flow throughout the engine. A modified water pump is available to reduce this concern.

Customers complaining of this noise should have the vehicle inspected, and if necessary, the water pump replaced.

REPAIR PROCEDURE

1.

Verify the concern.

^

If the noise is present, replace the water pump according to the workshop manual.

^

If the noise is not present but the temperature gauge fluctuates, refer to the workshop manual for troubleshooting and repair information.

CAUTION:

Follow all precautions listed in the workshop manual.

NOTE:

Verification should be conducted on a cold engine during the warm-up cycle.

2.

Verify repair.

PARTS INFORMATION

WARRANTY INFORMATION

(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
information.)

Warranty Type:

A

Symptom Code:

82

Damage Code:

9H

Part Number Main Cause:

ZZN2-15-010

Quantity:

1

Heater Core - Thump Noise/Temperature Gauge Erratic|Page 5032 > < Heater Control Valve|Testing and Inspection|Page 5023