B4000 Regular Cab 4WD V6-4.0L OHV (1997)
CAUTION:
^
Universal joint components from different manufacturers and new and used universal joints are never to be mixed. Universal joint kits are to be
installed as complete assemblies only.
^
Before assembly, make sure all parts are completely clean.
NOTE: Mark all propeller shaft components before disassembly. Vibration may be present if any component is not assembled in the original position.
PROCEDURE
Disassemble in the order shown in the illustration, referring to the following notes:
Snap Ring (1)
WARNING: Do not clamp the propeller shaft in a vise. The propeller shaft could fail during vehicle operation due to a dent or fracture
caused by the vise.
-
Remove the snap rings with pliers. Discard the snap rings.
NOTE: The snap rings cannot be reused.
Bearing Cup (2)
1. Clamp U-Joint Tool T74P-4635-C, or equivalent in a vise.
2. Position the yoke in the tool and press out the bearing cup.
