B4000 Regular Cab 4WD V6-4.0L OHV (1997)
CAUTION: Before assembly, make sure all parts are completely clean.
Assemble in the reverse order of disassembly, referring to the following notes:
Dust Boot, Slip Yoke (8, 9)
1. Install the dust boot making sure the boot is seated in the boot groove.
2. Install the small diameter side first, pushing the boot as far as it will travel on the stub shaft.
3. Install the small clamp by crimping with Clamp Pliers T63P-9171-A, or equivalent.
4. Fill the dust boot with approximately 10 grams (0.35 ounces) of grease.
5. Lubricate the slip splices with grease.
6. Push the slip yoke onto the stub shaft, making sure the blind splines are aligned.
