B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
Power Steering Fluid: Testing and Inspection
FINAL FILL INSPECTION
Caution: Do not mix oil types, any mixture or any unapproved oil could lead to seal deterioration and leaks. A leak could ultimately cause loss of
fluid, which could result in a loss of power steering assist.
1. Fill the reservoir with the appropriate fluid.
2. Remove fuse 19 (25A) form I/P fuse panel.
3. Raise the front wheels off the floor.
Caution:
^
Do not crank the engine for more than 15 seconds at a time. Allow the starter to cool for 1 minute before cranking again. Premature starter
failure can occur.
^
Do not hold the steering wheel against the stops for more than three to five seconds at a time. Damage to the power steering pump could occur.
4. Turn the steering wheel from stop-to-stop while cranking the engine. Check for fluid leakage.
5. Lower the vehicle.
Caution: Do not overfill the reservoir.
6. Fill the reservoir with the appropriate fluid.
7. Install I/P fuse panel fuse 19 (25A).
