B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
20. Disconnect the fuel injectors.
21. Disconnect the camshaft synchronizer.
22. Disconnect the oil pressure switch.
23. Remove the engine wiring harness.
Installation Note
1. Position the engine wiring harness.
2. Connect the oil pressure switch.
3. Connect the camshaft synchronizer.
4. Connect the fuel injectors.
5. Connect the two transmission harness electrical connectors.
6. Connect the two heated oxygen sensor electrical connectors.
7. Connect the engine wiring harness to the:
1. ECT sensor.
2. Water temperature indicator sender unit.
8. Connect the CKP sensor.
9. Install the upper intake manifold gasket.
10. Install the upper intake manifold.
11. Position the fuel line bracket.
12. Install the upper intake manifold nuts in the sequence shown.
13. Connect the spark plug wires.
14. Connect the engine wiring harness to the:
1. radio ignition interference capacitor.
2. ignition coil.
15. Connect the six spark plug wires.
16. Connect the TP sensor.
17. Connect the DPFE sensor vacuum lines.
18. Connect the crankcase ventilation tube.
19. Connect the vacuum lines to:
