B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
4X4
11. Remove the extension housing and discard extension housing gasket.
12. Clean the extension housing and install new extension housing gasket. Ensure that the parking pawl is correctly installed.
Caution Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
4X2
4X4
13. Position the extension housing and install screws and stud(s).
14. Position transmission mount on extension housing and install screws.
Tightening torque
68 - 95 Nm (6.9 - 9.7 kgf.m, 50 - 70 ft. lbs.)
15. Install transmission mount into crossmember and tighten transmission mount nuts.
Tightening torque
98 - 132 Nm (10 - 13.5 kgf.m, 73 - 97 ft. lbs.)
16. Install transfer case (4x4 only).
17. Align and install rear propeller shaft.
18. Connect battery negative cable.
19. Fill transmission to proper fluid level.
-
Use Mazda AFT TYPE 5 fluid.
20. Check for proper transmission operation.
EXTENSION HOUSING AND GASKET (4X4) REMOVAL/INSTALLATION
1. Disconnect the battery ground cable.
2. Raise and support the vehicle.
