B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
Output Shaft Bearing/Bushing: Service and Repair
EXTENSION HOUSING SEAL AND BUSHING REMOVAL/INSTALLATION
Removal Note
1. Raise and support the vehicle.
2. Mark the propeller shaft.
Note To maintain initial propeller shaft balance, mark the rear propeller shaft yoke and axle flange so they can be installed in their original
position.
3. Remove rear propeller shaft.
Caution Use the extension housing bushing remover carefully so that the seal area is not damaged.
4. Using SSTs, remove the extension housing seal.
5. Install SST or equivalent and remove extension housing bushing.
Installation Note
1. Position the extension housing bushing into the extension housing.
Caution The lube hole in the extension housing bushing must be aligned with the lube groove in the extension housing. This groove is located at
the 3 o'clock position when viewed from the rear.
Note Inspect the counterbore of the extension housing for burrs. Remove any burrs from the extension housing counterbore with an oil stone.
