B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
Caution Do not bend the manual valve inner lever pin.
2. Install the manual valve inner lever nut.
3. Install new extension housing gasket and install the extension housing.
4. If equipped, install the transfer case.
Note Align the drive shaft with the marks made during removal to ensure correct balance.
5. Install the rear propeller shaft bolts.
Note
-
Make sure the tab is in the lock position.
-
Install new O-rings on the transmission case (16 pin) electrical connector.
6. Install the transmission case (16 pin) electrical connector.
-
Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
Caution Align the slot on the TSS sensor electrical connector with the slot in the 16 pin case connector.