B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
11. Remove the transmission case (16 pin) electrical connector retaining spring.
Caution Do not damage the connector or harness.
12. Remove the transmission case (16 pin) electrical connector.
1. Compress the tabs on the transmission case (16 pin) electrical connector.
13. Push the transmission case (16 pin) electrical connector out of transmission case.
Installation Note
Note
-
Make sure the tab is in the lock position.
-
Install new O-rings on the transmission case (16 pin) electrical connector.
1. Install the transmission case (16 pin) electrical connector.
1. Lubricate the transmission case (16 pin) electrical connector O-rings with petroleum jelly.
Caution Align the slot on the TSS sensor electrical connector with the slot in the 16 pin case connector.