B4000 SE Cab Plus 4 4WD V6-4.0L OHV (2000)
5. Make sure the cups are properly seated in their bores.
6. Install the original oil slinger and rear bearing onto Middle Pinion SST 49 8531 565.
7. Install Collar B SST 49 UN27 004 and O-ring to Middle Pinion SST49 8531 565 and install them into the rear axle casing.
8. Install Collar A SST 49 UN27 003, yoke and washer.
9. Tighten the nut on Middle Pinion SST 49 8531 565 making sure the yoke can be turned by hand.
10. Tighten the nut on Middle Pinion SST 49 8531 565 making sure the yoke can be turned by hand.
11. Install Gauge Block (Front) SST 49 UN27 001 and Gauge Disc SST 205-129 onto Middle Pinion SST 49 8531 565.
12. Place SST assembly on a surface plate and set the dial indicator to zero.
13. Place Gauge Set SST 49 0727 570 on top of Gauge Block (Front) SST 49 UN27 001
14. Place the pointer of the dial indicator so that it contacts where the side bearing is installed in the housing. Measure the lowest position on the left
and right sides of the casing.
15. Add the right and left side measurements and divide by two to get the thickness dimension.
Specification: 0 mm (0 inch)
