B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
Brake Master Cylinder: Service and Repair
Brake Fluid Reservoir
BRAKE FLUID RESERVOIR REMOVAL/INSTALLATION
1. Disconnect the brake fluid level switch connector X-137.
2. Use a suitable suction device to drain the master cylinder reservoir.
3. Carefully pry up on the brake master cylinder reservoir to remove.
Note: Whenever replacing the brake master cylinder reservoir, replace the grommets.
4. Install the brake master cylinder reservoir.
(1 Lubricate grommets with appropriate brake fluid and insert in the brake master cylinder.
(2 Press the master cylinder reservoir into the grommets until it snaps.
(3 Connect brake fluid level switch connector X-137.
(4 Fill the brake master cylinder reservoir with appropriate brake fluid.