B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
Transfer Case Actuator: Service and Repair
Shift Motor
SHIFT MOTOR REMOVAL/INSTALLATION
1. Raise the vehicle on a hoist.
2. Disconnect the transfer case harness connector.
3. Remove the two bolts retaining the harness to the shift motor assembly and connector
4. Remove the rear bolt.
Note: Note the position of the triangular shaft extending out of the rear of the case.
5. Remove the remaining front bolt and the shift motor assembly and connector. Note the position of the triangular shaft extending out of the transfer
case cover.
Caution: Do not gouge or nick the aluminum surface.
6. Clean the mating surfaces of the shift motor and the transfer case cover.
Caution: The shift motor must be installed within 15 minutes of the application of silicone, or new sealant must be applied. If possible, allow one
hour before filling with lubricant to make sure the silicone sealant has properly cured.
7. Apply a thin coat of silicone to the shift motor housing base.
8. To install, reverse the removal procedure.
