B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
Band: Adjustments
BAND ADJUSTMENTS
Overdrive / Front Band
Caution:
-
Do not allow overdrive/front band adjustment screw to back out. Band strut could tall out of position.
Throw the locknut away. The locknut is not reusable for assembly.
1. Remove and discard the overdrive/front band locknut.
Note: The wrench will click at the specified torque.
2. Tighten overdrive/front band adjustment screw and back off overdrive/front band adjustment screw exactly two (2) turns and hold that position.
Caution:
-
Install, but do not tighten, a new locknut on the band adjustment screw. Apply petroleum jelly to the locknut seal.
The front servo must be installed prior to band adjustment.
3. While holding the overdrive/front band adjustment screw stationary, tighten the overdrive/front band locknut using a 19 mm wrench.
4. Install the digital transmission range (TR) sensor.
5. Install the shift cable.
1. Install the shift cable.
