B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
2. Install the shift cable to the manual control lever.
6. Lower the vehicle.
Intermediate Band
1. Raise and support the vehicle.
2. Remove the shift cable.
1. Disconnect the shift cable from the manual control lever.
2. Remove the shift cable from the bracket.
3. Remove the digital transmission range (TR) sensor.
Caution:
-
Do not allow intermediate band adjustment screw to back out. Band strut could fall out of position.
Throw the locknut away. The locknut is not reusable for assembly.
4. Remove and discard the intermediate band locknut.
Note: The wrench will click at the specified torque.
5. Tighten intermediate band adjustment screw and back off intermediate band adjustment screw exactly two and one-half (2 1/2) turns and hold that
position.
Caution:
-
Install, but do not tighten, a new locknut on the band adjustment screw. Apply petroleum jelly to the locknut seal.
The intermediate servo must be installed prior to band adjustment.