B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
4x4
10. Remove the extension housing and discard extension housing gasket.
11. Clean the extension housing and install new extension housing gasket. Ensure that the parking pawl is correctly installed.
Caution: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.
4x2
4x4
12. Position the extension housing and install screws and stud(s).
13. Position transmission mount on extension housing and install screws.
Tightening torque 68 - 95 Nm (6.9 - 9.7 kgf-m, 50 - 70 ft. lbs.)
14. Install transmission mount into crossmember and tighten transmission mount nuts.
Tightening torque 98 - 132 Nm (10 - 13.5 kgf-m, 73 - 97 ft. lbs.)
15. Install transfer case (4x4 only).
16. Align and install rear propeller shaft.
17. Fill transmission to proper fluid level.
-
Use equivalent.
18. Check for proper transmission operation.
EXTENSION HOUSING AND GASKET (4X4) REMOVAL / INSTALLATION
1. Raise and support the vehicle.
