B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
Clutch Slave Cylinder: Service and Repair
CLUTCH RELEASE CYLINDER REMOVAL / INSTALLATION
1. Remove the transmission.
Note: Inspect the clutch housing for traces of fluid. If fluid is visible, install a new clutch release cylinder.
2. Remove clutch release cylinder.
1. Remove the bolts.
2. Remove the clutch release cylinder.
3. Inspect the clutch release cylinder for the following:
1. Worn or damages boot.
2. Leaking fluid.
3. Worn or damaged bearing.
4. Inspect the clutch release bearing as follows:
1. Rotate the outer race while applying pressure. If the bearing rotation is rough, install a new clutch release cylinder.
2. Inspect for wear or damage.
1. If wear is continuous knot segmented and the wear appears to be deep in bearing face, install a new clutch release cylinder.
5. To install, reverse the removal procedure.
1. Position the clutch release cylinder and install the bolts.
6. Install the transmission.