B4000 SE Cab Plus 4 4WD V6-4.0L SOHC (2001)
1. Position Pinion Bearing Cup Replacer SST49 UN01035 and the inner and outer bearing cups in their respective bores.
1. After placing the inner and outer bearing cups in their bores, place SST 49 UN01 035 (inner) on the inner pinion bearing cup.
2. Place SST 49 UN01 035 (outer) on the outer pinion bearing cup.
3. Install SST 49 UN01 035.
2. Tighten SST 49 UN01 035 to seat the pinion bearing cups into their bores.
Note: Steps 3 and 4 are an alternate method of performing Steps 1 and 2.
3. Drive the outer pinion bearing cup into the axle housing using Driver Handle SST 49 F027 003 and Pinion Bearing Cup Replacer SST 49 UN01
035.
4. Drive the inner pinion bearing cup into the axle housing using Driver Handle SST 49 F027 003 and Pinion Bearing Cup Replacer SST 49 UN01
035.
Caution: Whenever the cups are replaced, the pinion bearings must also be replaced.
Note: If a feeler gauge can be inserted between a cup and the bottom of its bore at any point around the cup, the cup is not properly seated.
