B4000 SE Cab Plus 4WD V6-4.0L OHV (1997)
e. Install and connect the PCV valve.
f.
Connect the hoses to vacuum tee "A".
g. Install the power brake vacuum hose.
h. Install the A/C compressor.
^
Tighten the bolts to 24-30 Nm (18-23 ft. lbs.)
i.
Connect the A/C compressor clutch connector, if equipped.
j.
Install the upper intake manifold.
2. If installing the right cylinder head cover, perform the following:
a. Install a new cylinder head cover gasket.
b. Install the cylinder head cover, reinforcement plates and cylinder head cover bolts.
d. Install the right wiring harness and push down on the clip.
e. Connect the filler neck vacuum hose.
^
Press the coupling to the filler neck to install the filler neck vacuum hose.
f.
Install two wiring harnesses onto the right cylinder head cover.
g. Install the ignition coil pack.
h. Install the generator.
3. Install the high tension leads onto the cylinder head covers.
4. Install the air conditioning pipe bolt onto the upper intake manifold, if equipped.
