B4000 SE Cab Plus 4WD V6-4.0L OHV (1997)
^
Install the bearing with the manufacturer's identification facing outward.
^
Clean all dirt and grease from the bearing bore. The bearing bore must be free from nicks and burrs.
Oil Seal (13)
^
Install the oil seal using the SSTs.
NOTE: Apply high temperature grease to the oil seal.
Rubber Boot (12)
^
If installing the right front drive axle shaft, install the rubber boot onto the front drive axle shaft.
Clamps (10)
^
If installing the right front drive axle shaft, refer to the following:
a. Align the marks made during removal.
b. Install the clamps using Clamp Pliers T63P-9171-A, or equivalent.
Spindle (7)
^
Install the spindle and nuts. Tighten nuts to 54 - 68 Nm (40 - 50 ft. lbs.).
Inner Bearing Cup (5)
^
Install the inner bearing cup using the SST and Bearing Cup Replacer T73T-4222-B, or equivalent.
NOTE: SST number: 49 F027 003 Driver Handle.
Outer Bearing Cup (6)
^
Install the outer bearing cup using the SST and Bearing Cup Replacer T73T-4222-B, or equivalent.
NOTE: SST number: 49 F027 003 Driver Handle.
Inner And Outer Bearing (2, 4)
^
Pack the bearings with high temperature grease.
Seal (3)
^
Install the seal using the SSTs.
NOTE: Apply high temperature grease to the seal.
