B4000 SE Cab Plus 4WD V6-4.0L OHV (1997)
8. Loosen the inner locknut using the SST.
9. Rotate the disc plate counterclockwise while tightening the inner locknut to 47 Nm (35 ft. lbs.).
10. Spin the disc plate and loosen the inner locknut one-quarter turn (90°).
11. Tighten the inner locknut to 1.8 Nm (16 inch lbs.) using the SST.
NOTE: SST number: 49 UN01 042 Hub Locknut Wrench
12. Install the washer.
NOTE: Tighten the inner locknut slightly to align the locknut pin with the washer hole.
13. Tighten the outer locknut to 203 Nm (150 ft. lbs.) using the SST.
14. Check the wheel bearing play. Wheel bearing play should be within 0.00 - 0.08 mm (0.00 - 0.003 inch).
15. Attach a pull scale to a wheel lug bolt and measure the frictional force. Frictional force should be 2.8 Nm (25 inch lbs.).
16. Install the axle shaft spacers.
17. Install the snap ring.
18. Install the manual locking hub assembly.
19. Install the retainers.