B4000 SE Cab Plus 4WD V6-4.0L OHV (1997)
5. Install the six screws and finger tighten.
6. Select the correct arbor from the SST that will be the tightest fit when placed over the pump support.
CAUTION: The SST must be used to properly align the pump to the converter housing, in order to prevent seal leakage, gear noise and
breakage and bushing failure.
7. Thread the arbor into a common handle and slide the SST over the pump support until it bottoms in the pump gear pocket.
8. Tighten the six screws to 22 - 28 Nm (16 - 21 ft. lbs.).
9. Remove the SST.
