B4000 SE Cab Plus 4WD V6-4.0L OHV (1997)
NOTE:
Use Resin core Mildly Activated (RMA) solder. (Do not use acid core solder).
6.
Reposition the heat shrink tubing over the splice.
7.
Heat the entire length of heat shrink tubing until the sealant comes out of both ends.
NOTE:
Use a heat gun only. Do not use a hair dryer or any flames to heat the shrink tubing.
8.
Secure the wire to the harness.
9.
Leave the sensor installed in the case (if applicable).
PARTS INFORMATION
Part Number
Description
ZZN0-19-376
Transmission Case (without ODS Hole)
WARRANTY INFORMATION
(Applies To Verified Customer Complaints On Vehicles Covered Under Normal Warranty. Refer To The SRT Microfiche For Warranty Term
Information.)
Warranty Type:
A
Symptom Code:
74
Damage Code:
9V
Part Number Main Cause:
ZZN0-1 9-376
Quantity:
0
Operation Number:
YY146XRX
Labor Hrs:
0.3 Hrs.