B4000 SE Cab Plus 2WD V6-4.0L OHV (1998)
Torque to 20-25 Nm (15-18 ft.lbs.)
Connect the spark plug wires to the ignition coil.
NOTE:
-
Wipe the spark plug wires with a clean, damp cloth prior to inspection.
-
When a spark plug wire is removed for any reason from a spark plug or ignition coil, or a new spark plug wire is installed, silicone must be applied
to the spark plug wire boot prior to installation.
-
Use a small, clean tool to coat the entire interior surface of the boot with silicone or equivalent.
CAUTION: Proper installation of the spark plug wires is critical to vehicle operation. If one spark plug wire is not properly installed on the spark
plug or ignition coil, both spark plugs connected to that segment of the ignition coil may not fire under load.
