B4000 SE Cab Plus 2WD V6-4.0L OHV (1998)
Alignment: Service and Repair
Camber and Caster Adjustment
1. Remove the nuts and alignment plates.
2. Install the service cams and the nuts.
NOTE: A pry bar can be used between the front suspension arm bushing joint and the frame pocket to aid in moving the arm.
NOTE: When adjusting the RF camber/caster, adjustment at the RF lower control arm adjustment cam is not recommended.
3. To increase caster and camber, use the following steps.
(1) To increase caster, move the front of the front suspension arm bushing joint outboard and move the rear of the front suspension arm bushing
joint inboard.
(2) To increase camber, move the front suspension arm bushing joint outboard equally.
4. To decrease caster and camber, use the following steps.
(1) To decrease caster, move the front of the front suspension arm bushing joint inboard and move the rear of the front suspension arm bushing
joint outboard.
(2) To decrease camber, move the front suspension arm bushing joint inboard equally.