B4000 SE Cab Plus 2WD V6-4.0L OHV (1998)
Axle Shaft: Service and Repair
Limited Slip Differential
AXLE SHAFT (LIMITED SLIP) REMOVAL / INSTALLATION
REMOVAL NOTE
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the axle housing cover and drain the lubricant.
4. Remove the rear brake drums.
5. Remove the differential pinion shaft.
1) Remove the differential pinion shaft lock bolt.
2) Remove the differential pinion shaft.
CAUTION: Do not damage the rubber O-rings in the U-washer grooves.
6. Remove the u-washers.
1) Push the axle shafts inboard.
2) Remove the u-washers.
CAUTION: Do not damage the inner wheel bearing oil seal.
7. Remove the two axle shafts.
INSTALLATION NOTE
1. Lubricate the lip of the inner wheel bearing oil seal.
CAUTION: Do not damage the inner wheel bearing oil seal.
2. Install the two axle shafts.
CAUTION: Do not damage the rubber O-rings in the U-washer grooves.