B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
or PASSENGER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION.
2. Cut the two air bag connector wires and strip 25 mm (1 inch) of insulation from the ends.
3. Obtain two wires at least 6 m (20 feet). Connect one end of each wire to each of the air bag module wires.
WARNING: Do not place the air bag with the trim cover facing down, as the forces of the deployed air bag may cause it to ricochet and
cause personal injury.
4. Place the air bag with the trim cover facing upward on a flat surface in an open, outdoor area.
5. Remaining at least 6 m (20 feet) away from the air bag.
6. Deploy the air bag by touching the other ends of the two wires to the terminals of a 12 volt battery.
7. Allow at least 10 minutes before approaching the air bag to allow for cooling.
The air bag is now deployed and may be scrapped in accordance with scrap metal procedures.
