B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
Power Steering Pump: Service and Repair
Power Steering Pump Pulley
POWER STEERING OIL PUMP PULLEY REMOVAL/INSTALLATION
Removal Note
1. Remove the drive belt.
2. Remove the power steering pump pulley, using Pulley Remover Tool 211-016 (T69L-10-300B) or equivalent.
Installation Note
Caution: Replacement of the power steering pump pulley Is necessary after being removed and Installed two times.
1. Install the power steering pump pulley.
1) Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
2) Use Pulley Replacer Tool 211-185 (T91-3A-733A) or equivalent.
2. Install the drive belt.