B4000 SE Regular Cab 4WD V6-4.0L OHV (1999)
30. Move the LH front wheel spindle tie-rod forward to clear the frame crossmember.
31. Remove the steering near from the vehicle.
Installation Note
1. Install new seals on the power steering return hose and power steering pressure hose using SST D90P-3517A or equivalent.
Note:
-
Make sure the steering gear input shaft is turned to the left until the stop is reached.
-
Handle the steering gear with caution to avoid damage to fluid transfer tubes and to avoid dimples in tie-rod boots.
2. Turn the steering gear input shaft to the right until the stop is reached. Note the number of turns required.
Note: Make sure the steering gear control valve housing is turned toward the front of the vehicle.
3. Install the steering gear into the RH opening of the crossmember.